Renesas M37900T2-RPD-E Note on Self-check:

( 35 / 52 )

IMPORTANT

Note on Self-check:

•If the self-check does not result normally (excluding target status errors), the

emulation pod may be damaged. Contact your local distributor.

(2) If an Error is Detected in the Self-check

If the self-check does not result normally (ERROR 1 and ERROR 2 in Figure 4.3), check the

following.

•Check the connection of the emulation pod and the PC4701.

• Check the connection of the emulation pod and the pod probe.

•Redownload the proper firmware.

•Check if the switches in the pod probe are set same as the factory-setting (refer to the user's

manual of the pod probe).

Contents

Main ( 2 / 52 ) Preface To use the product properly Precautions for Safety When using outside Japan Contents Page Page Page Chapter 1. Precautions for Safety WARNING IMPORTANT CAUTION WARNING Warning for Installation: Warnings for Use Environment: Caution to Be Taken for Modifying This Product: Cautions to Be Taken for This Product: Notes on Power Supply to the Target System: Notes on Downloading Firmware: Note on Malfunctions in the PC4701 System: Notes on the Self-check: Note on Quitting the Emulator Debugger: Notes on EMEM Dialog: Page Page Chapter 2. Preparation 2.1 Terminology 2.2 Package Components 2.3 Other Tool Products Required for Development 2.4 Name of Each Part (1) System Configuration (2) Inside of the Emulation Pod 2.5 When Using the Emulator for the First Time Page Chapter 3. Setting Up 3.1 Selecting Clock Supply Note on Changing the Clock Supply: (1) Using the Oscillator Circuit on the Target System Notes on External Clock: Page (3) Replacing the Oscillator Circuit Boards When Removing the Upper Cover: 3.2 Connecting the Pod Probe and Emulation Pod When Connecting Pod Probe: Page Page Page Page Chapter 4. Usage 4.1 Turning on Power (1) Checking the Connection of the System (2) Turning on Power Notes on Power Supply: Note on Memory Expansion Mode and Microprocessor Mode: 4.2 Downloading Firmware (1) When It is Necessary to Download Firmware (2) Downloading Firmware in Maintenance Mode Note on Downloading Firmware: 4.3 Starting Up the Emulator Debugger (Setting EMEM Dialog) 4.4 Self-check (1) Self-check Procedure Note on Self-check: (2) If an Error is Detected in the Self-check Page Page Chapter 5. Specifications 5.1 Specifications Page Page Chapter 6. Troubleshooting ( 42 / 52 ) Chapter 6. Troubleshooting 6.1 Flowchart to Remedy the Troubles Figure 6.1 Flowchart to remedy the troubles 6.2 When the Emulator Debugger Does Not Start Up Properly (1) When the LED Display of the PC4701 is Abnormal Table 6.1 LED's abnormal display and its checkpoints (2) Errors Occur at Debugger Startup (target connected) Table 6.2 Checkpoints of errors of the emulator debugger M3T-PD79 (target is connected) See the user's manuals of the PC4701 and emulator debugger. See "4.2 Downloading Firmware" (page 32). See the user's manual of the pod probe See "3.3 Connecting the PC4701 and Emulation Pod" (page 26). (3) Errors Occur at Debugger Startup (target not connected) Table 6.3 Checkpoints of errors of the emulator debugger M3T-PD79 (target is not connected) 6.3 Operation Differs from that of MCUs with Flash Memory Page Chapter 7. Maintenance and Guarantee 7.1 Maintenance 7.2 Guarantee 7.3 Repair Provisions 7.4 How to Request for Repair Note on Transporting the Product: