Section 3 Connection Procedures
Rev. 1.00 Nov. 18, 2008 Page 9 of 18
REJ10J1937-0100
3.1.3 Connecting Common User-System Interface Adaptor Cable (Board Unit) to
EV-Chip Unit
WARNING
Observe the precautions listed below. Failure to do so
will result in a FIRE HAZARD and will damage the user
system and the emulator product or will result in
PERSONAL INJURY. The USER PROGRAM will be LOST.
1.Always switch OFF the user system and the emulator
product before the USER SYSTEM INTERFACE CABLE
is connected to or removed from any part. Before
connecting, make sure that pin 1 on both sides are
correctly aligned.
2.The user system interface cable dedicated to the
emulator must be used.
1. Make sure the user system and emulator are turned off.
2. Align the connectors on the common user-system interface adaptor cable (board unit) with
those on the EV-chip unit according to their numbers (figure 4).
3. Adjust the height of the spacer attached to the common user-system interface adaptor cable
(board unit) with the user system.