6
You can set the ramp/settle time in 5-minute intervals, from 0 minutes (OFF) up
to a maximum time set by your clinician.
The current ramp or settling time is displayed in the right corner of the standby
screen.
1Press or until the desired ramp or settling time appears.
2Once a ramp or settling time is selected, begin therapy by pressing .
When ramping or settling begins the LCD will display the word “RAMPING or
APAP“ depending on the mode, with the current pressure indicated as dashes.
Each dash is approximately equivalent to 2 cm H2O. For example, six dashes
represents approximately 12 cm H2O pressure.
How to change the EPR level
EPR can be used to help ease any discomfort you may experience when
breathing out during treatment. If your clinician has allowed access you can
change the EPR level. There are four settings: OFF; 1 (lowest EPR); 2; and 3
(highest EPR).
1On the standby (RAMP/SETTLE) screen, press (Menu).
2Press until you see EPR LEVEL, then press (Change).
3Press or until you see the setting that you require.
4Press (Apply) to save the setting.
How to change the language setting
1On the standby (RAMP/SETTLE) screen, press (Menu).
2Press until you see LANG (Language), then press (Change).
3Press or until you see the language that you require.
4Press (Apply) to save the new language.
Messages on the S8 Escape II Auto LCD
Your clinician may have set your S8 Escape II Auto to remind you about important
events, such as when to replace your mask, when to insert your Data Card (if
your device is Data Card enabled) and so on.
The reminder message is displayed on the LCD and is visible if the device is not
delivering therapy. The backlight on the LCD flashes when a message is
displayed.