Revolabs Single Channel System - Polycom HDX 9004 Setup Guide
NOTES AND CAUTIONS:
This setup guide will guide you through the steps needed to properly connect a Revolabs Single Channel System to a Polycom HDX 9004 video codec.
1.Connecting the Cables
2.Configuring the HDX 9004 Video Codec
Note: It is important to carefully follow these instructions in order and completely . Otherwise your Single Channel System and/or the video codec may not function properly. Please read through these instructions completely before proceeding. Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1.Revolabs Single Channel System
2.Revolabs 2.5mm to RCA Audio Cable (included with Single Channel)
3.Polycom HDX 9004 video codec
4.Polycom Audio Adapter Cable (P/N
*POLYCOM HDX 9000 SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FOR AUDIO INPUT/OUTPUT WHILE REVOLABS SINGLE CHANNEL SYSTEM PRODUCTS USE RCA CONNECTORS FOR AUDIO INPUT/OUTPUT. THE POLYCOM AUDIO ADAPTER CABLE CONVERTS TWO PHOENIX CONNECTORS INTO FEMALE RCA CONNECTORS. OTHERWISE, A TECHNICIAN COULD SIMPLY CUT OFF THE ENDS OF THE RCA CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE:
