Riccar RSL1AC Postioning the Power Cord, Models RSL3, RSL4, RSL5, RSL3C and RSL5C

Assembling the Vacuum

Model: RSL1A and RSL1AC cont.

3.Place the handle bracket back into position (figure 3).

4.Secure with two screws removed in step 1.

Postioning the Power Cord: Fig. 3

1.Loosen, but do not remove, the screw holding the upper cord hook (figure 4).

2.Position the cord between the cord hook and the vacuum tube (figure 5). Re-tighten the screw.

3.Once the cord is secured by the cord hook, proceed with wrapping the cord.

Fig. 4

4.Wrap the cord clockwise around the top and bottom cord hooks. Fasten the plug to the wrapped cord using the channel on the plug. When not in use, store the vacuum indoors in a clean, dry area where it can not be damaged or cause injury.

Fig. 5

Assembling the Vacuum

Models: RSL3, RSL4, RSL5, RSL3C and RSL5C

The vacuum cleaner handle is packed as a separate component that requires assembly.

Fig. 6

Installing the Handle

1.Release the handle bracket from the handle tube by removing the two screws (figure 6).

2.Place handle onto the handle tube, aligning holes with pegs (figure 7).

3.Place the handle bracket back into position (figure 8).

Fig. 7

4.	Secure with two screws removed in step 1.
5.	Thread cord through cord guides and proceed
	with wrapping the cord (figures 9a & 9b).
6.	Wrap the cord clockwise around the top and
	bottom cord hooks. Fasten the plug to the
	wrapped cord using the channel on the plug.
	When not in use, store the vacuum indoors in
	a clean, dry area where it can not be damaged
	or cause injury.	Fig. 8

Fig. 9a Fig. 9b

8 9