600 Power Drive
10.When dies clear the end of the pipe, grip the handle on top of the Power Drive and remove the Power Drive and Die Head from the pipe.
11.Remove the support arm from the pipe and the pipe from the vise.
WARNING To avoid injury, make sure long sections of pipe are supported at the end farthest away from the vise prior to removal.
12.Clean up any oil spills or splatter on the ground sur- rounding the vise and oiler.
Accessories
WARNING
Only the following RIDGID products have been designed to function with the 600 Power Drive. Other accessories designed for use with other tools may become haz- ardous when used on this Power Drive. To prevent serious injury, use only the accessories listed below.
Accessories For Power Drive
Model No. | Description | |
418 | Oiler with 1 Gallon of | |
601 | Support Arm | |
|
| |
— | Carrying Case |
|
|
|
|
— | Gearhead Motor Grease | |
|
|
|
NOTE! See Ridge Tool catalog for listing of
Maintenance Instructions
WARNING
Make sure machine is unplugged from power source before performing maintenance or mak- ing any adjustment.
Motor Brush Replacement
Check motor brushes every 6 months and replace brushes when they are worn to less than 1/4″ .
Tool Storage
WARNING
Service and Repair
WARNING
Service and repair work on this Power Drive must be per- formed by qualified repair personnel. Tool should be taken to a RIDGID Independent Authorized Service Center or returned to the factory. All repairs made by Ridge service facilities are warranted against defects in material and workmanship.
When servicing this Power Drive, only identical replace- ment parts should be used. Failure to follow these instructions may create a risk of electrical shock or other serious injury.
If you have any questions regarding the service or repair of this machine, call or write to:
Ridge Tool Company Technical Service Department 400 Clark Street
Elyria, Ohio
For name and address of your nearest Independent Authorized Service Center, contact the Ridge Tool Company at (800)
Ridge Tool Company | 7 |
