ASSEMBLY

EXTENSION BAR(S) OPERATION

See Figures 10 and 11.

Both extension bars may be adjusted to provide maximum workpiece support. To adjust the extension bars:

n Loosen adjustable handle by turning counter clockwise.

NOTE: Adjustable handle can be repositioned if necessary. Lift up on handle and rotate to desired position then release handle.

nSlide out extension bar to desired position and tighten extension bar handle.

ADJUSTABLE

HANDLE

LOCKING PIN

KNOB

Fig. 10

NOTE: There is a catch to limit the overall extension bar travel.

nPull out on locking pin knob and swing leg down until locking pin locks leg in the down position.

nTurn foot knob counterclockwise to loosen and slide foot extension down until foot contacts the floor. Tighten foot knob.

nRepeat for the other extension bar.

NOTE: It may be necessary to realign roller assemblies with the miter saw table. See Mounting and Aligning Roller Assembly on page 9.

LEG

FOOT

KNOB

Fig. 11

10

Page 10
Image 10
RIDGID AC9940 manual Extension Bars Operation, See Figures 10, Adjustable Handle Locking PIN Knob, LEG Foot Knob