Drive Belt
Belt stretch is a result of normal use. When properly adjusted, the belt deflects about 1/2” with five pounds of pressure applied midway between the engine pulley and pump.
To adjust drive belt tension:
1.Remove belt guard and loosen engine brace.
2.Loosen the four fasteners holding the engine to the baseplate.
3.Shift the engine in the proper direc- tion. The belt must be properly aligned when adjustment is made.
4.To align belt, lay a straight edge against the face of the flywheel, touching the rim at two places.
5.Adjust flywheel or engine pulley so that the belt runs parallel to the straight edge.
6.Use a gear puller to move the pulley on the shaft and tighten fasteners.
7.Adjust brace and reinstall belt guard.
1/2” Deflection
Belt
Straight Edge
Touch Rim of
Flywheel in Two
Places
Straight Edge Parallel With Belt
Storage
1.When not in use, hose and compres- sor should be stored in a cool, dry place.
2.Tanks should be drained of moisture.
3.Hose should be disconnected and hung with open ends down to allow any moisture to drain.
15