OPERATION
WRONG
Fig. 35
WARNING:
To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.
CLAMPING WIDE WORKPIECES
See Figure 36.
When cutting wide workpieces, such as 2 in. x 6 in., boards should be clamped with a
WIDE BOARD | Fig. 36 |
|
MAINTENANCE
WARNING: WARNING:
When servicing, use only identical replacement parts. Use of any other part may create a hazard or cause product damage.
Do not at any time let brake fluids, gasoline, petro-
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrica- tion is required.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
To ensure safety and reliability, all repairs should be performed by a qualified service technician at an authorized service center to avoid risk of personal injury.
30