MAINTENANCE
WARNING:
When servicing use only identical RIDGID® replace- ment parts. Use of any other parts may create a hazard or cause product damage.
GENERAL
Avoid using solvents when cleaning plastic parts. Most plas- tics are susceptible to damage from various types of com- mercial solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petro-
Electric tools used on fiberglass material, wallboard, spack- ling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, com- mutators, etc. Consequently, we do not recommended us- ing this tool for extended work on these types of materials. However, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
ACCESSORIES
WARNING:
Always wear safety goggles or safety glasses with side shields when operating this tool. Failure to do so could result in dust, shavings, or loose particles being thrown into your eyes, resulting in possible serious injury.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the tool under normal operating conditions. Therefore, no further lubrica- tion is required.
The following recommended accessories are currently available at retail stores: |
|
■ Mixing Wands |
|
■ High Speed Bits | 1/2 in.(13 mm) Max. |
■ Wood Boring Bits | |
■ Self Feed | |
■ Auger Bit | |
■ Hole Saw, Steel | 3 in. (76.2 mm) Max. |
■ Hole Saw, Wood | 5 in. (127 mm) Max. |
WARNING:
The use of attachments or accessories not listed might be hazardous.
15
