![](/images/new-backgrounds/1314371/31437123x1.webp)
OPERATION
TO INSTALL BATTERY PACK
nLock the switch trigger on the drill by placing the direction of rotation
nPlace battery pack in the drill. Align raised rib on battery pack with the groove inside the drill. See Figure 5.
nMake sure the latches on each side of your battery pack snap in place and battery pack is secured in the drill before beginning operation.
CAUTION:
When placing battery pack in the tool, be sure raised rib on battery pack aligns with the slide on the bottom of the drill and latches snap into place properly. Improper assembly of the battery pack can cause damage to internal components.
TO REMOVE BATTERY PACK
nLock the switch trigger on the drill by placing the direction of rotation selector in center position.
See Figure 4.
nLocate latches on side of battery pack and depress to release battery pack from the drill. See Figure 5.
nThe battery pack will automatically disconnect in direction to be removed when buttons are depressed.
nRemove the battery pack from your drill.
SWITCH
See Figure 6.
To turn your drill ON, depress the switch trigger. To turn it OFF, release the switch trigger.
VARIABLE SPEED
See Figure 6.
This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
This drill has an electric brake. When the trigger switch is released, the chuck stops turning. When the brake is functioning properly, sparks will be visible through the vent slots on the housing. This is normal and is the action of the brake.
Note: You might hear a whistling or ringing noise from the switch during use. Do not be concerned, this is a normal part of the switch function.
SELECTOR WITH CENTER
LOCK POSITION
REVERSE
FORWARD
Fig. 4
DEPRESS LATCHES TO |
|
RELEASE BATTERY PACK | Fig. 5 |
VARIABLE SPEED
SWITCH TRIGGER
Fig. 6
12