RIDGID R845 manual STARTING/STOPPING the SAW, Depth of CUT Adjustment, To Adjust Blade Depth

OPERATION

LOCK-OFF BUTTON

See Figure 12.

The lock-off button reduces the possibility of accidental starting. The lock-off button is located on the handle above the switch trigger. The lock-off button must be depressed before you pull the switch trigger. The lock resets each time the trigger is released.

NOTE: You can depress the lock-off button from either the left or right side.

STARTING/STOPPING THE SAW

See Figure 12.

To start the saw:

nDepress the lock-off button.

nDepress the switch trigger.

Always let the blade reach full speed, then guide the saw into the workpiece.

WARNING:

The blade coming in contact with the workpiece before it reaches full speed could cause the saw to “kickback” towards you resulting in serious injury.

To stop the saw: Release the switch trigger.

After you release the switch trigger, allow the blade to come to a complete stop. Do not remove the saw from

the workpiece while the blade is moving.

DEPTH OF CUT ADJUSTMENT

See Figure 13.

Always keep correct blade depth setting. The correct blade depth setting for all cuts should not exceed 1/4 in. below the material to be cut. More blade depth will increase the chance of kickback and cause the cut to be rough. One blade tooth below the material to be cut works best for most efficient cutting action.

TO ADJUST BLADE DEPTH

nRemove battery pack from saw.

nLoosen depth adjustment knob.

nHold base flat against the workpiece and raise or lower saw until the required depth is reached.

nTighten depth adjustment knob securely.

50

45 30

LOCK-OFF

BUTTON

SWITCH

TRIGGER

6

5

4

Fig. 12

DEPTH ADJUSTMENT

KNOB

Fig. 13

16