OPERATION
TO INSTALL BATTERY PACK
See Figure 7.
Place the battery pack in the impact driver, aligning raised rib on battery pack with groove in the driver’s battery port.
Make sure the latches on each side of the battery pack snap into place and the battery pack is secured to the impact driver before beginning operation.
TO REMOVE BATTERY PACK
See Figure 8.
Locate the latches on the side of the battery pack and depress both sides to release the battery pack from the impact driver.
Remove the battery pack.
WARNING:
Battery tools are always in operating condition. Therefore, switch should always be locked when not in use or carrying at your side.
SWITCH TRIGGER
See Figure 9.
To turn the impact driver ON, depress the switch trigger. To turn it OFF, release the switch trigger.
VARIABLE SPEED
See Figure 9.
This tool has a variable speed switch that delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
NOTE: You might hear a whistling or ringing noise from the switch during use. Do not be concerned; this is a normal part of the switch function.
RAISED RIBS
LATCH
Fig. 7
18V BATTERY PACK
LATCH
DEPRESS LATCHES TO
RELEASE BATTERY PACK
24V BATTERY PACK
LATCH | Fig. 8 |
15
