Rinnai RHFE-750ETR installation manual Fla m e

Rinnai Corporation RHFE-750ETR 9
Adjusting the Temperature
Pressing the UP and DOWN buttons will change the
temperature setting by 2 degree (F)
increments. The display will show
“Temperature” and the new temperature as
confirmation.
The temperature can be set to:
• L (Low) - burner is on minimum
combustion
• 60° F - 80° F in two
degree increments
• H (High) - burner is
on maximum combustion
To use Celsius scale,
open the battery
compartment and move
the switch toward “0”.
The temperatures 16-26° C are available in one
degree increments. To return to Fahrenheit scale
move the switch toward “1”.
Tem p er a t ur e
Lock
Clo c k
PM
Tim er 1
Set
Set ON OFF
ON OFFTim er 2 Set
Overri d e Aut o Off Flame
Flame Function
Press the FLAME button to control the flame
level. There are seven levels of flame
available.
The display will show the
word “Flame” and a series
of short bars (one for each
flame level).
Use the UP or DOWN
buttons to select the
desired flame level.
Pressing the FLAME
button again will allow the
appliance to control the
flame automatically.
If the room temperature reaches 104° F (40° C) while
the flame function is on then the appliance will turn off
automatically as a safety precaution.
The FLAME function is not available during TIMER
operation.
Tem p er a t ur e
Lock
Clo c k
AM
PM
Tim er 1
Set
Set ON OFF
ON OFFTim er 2 Set
Overri de
Tim e
Fla m e
Fla m e
Lock Function
Pressing the LOCK button will cause all
functions of the remote control to be locked
except for the STANDBY/ON button.
The remote control
display will show the word
“Lock” in the top left
corner.
To cancel the Lock
function press down and
hold the LOCK button for
3 seconds.
Tem p er a t ur e
Lock
AM
PM
Overri de
Tim e
Lock
Auto Off Function
When the appliance is not in AUTO OFF mode and
the room temperature reaches the temperature
setting the appliance will reduce the gas
flow and maintain the flame on the lowest
flame level. The temperature may continue
to rise even on this low setting. If the
temperature reaches
104° F (40° C) then the
appliance will
automatically shut down
with fault code 16.
In AUTO OFF mode the
gas flow will be reduced
to pilot operation with no
visible flame when the
temperature setting is
reached. To enter this
mode press the AUTO OFF button. The words “Auto
Off” will be displayed above the time. To exit this
mode press the AUTO OFF again.
Whether this mode is on or off, the appliance will
attempt to maintain the temperature setting.
Tem p er at ur e
Lock
Clo c k
AM
PM
Tim er 1
Set
Set ON O FF
ON OFFTim er 2 Set
Overri deAut o Off
Tim e
Fla m e
Aut o
Off
Obstruction of Warm Air Discharge
Obstructing the louvers for the warm air discharge will
cause the appliance to operate inefficiently.
When an obstruction is detected the Blockage
Indicator LED above the Receiver Window will glow
red and combustion reduces to front burner, low
operation only.
To restore normal operation, remove the obstruction,
turn the appliance OFF and then ON.
Basic Fireplace Operations