RiteTemp Internal Document
Filling the Cooler
Removing Side Tanks
Make sure unit is unplugged from wall. Remove the side water tanks by lifting up and then away from the cooler. Take tanks and faucet attachment hose to sink or other water source. Stand tanks upside down on stable surface.
Fill Tanks
With the water turned off, connect the white funnel end of the attachment hose to faucet. Remove the tank’s cap and insert the clear tube. Fill tank with cold water then replace the cap making sure it is seated correctly and is tight to avoid any leakage. Repeat process for other tank.
Reconnecting tanks to main unit
Remove filler hose from faucet and take water tank back to main unit. Replace each side tank. Making sure that the water nozzle sets directly into the cooler base and the top lip aligns securely with the notches at the top of the unit.
(*Please note it may take up to 5 minutes for the water to transfer to the main tank on the first fill)
R i t e T e m p
End of Season Maintenance and Storage continued
Getting Cooler Ready for Storage continued
Next put base unit on its side wheels down and allow wa- ter to drain out. Leave base unit in this position until it is completely dried out.
This is a good time to clean out the drip tub. This can be done by using a paper clip and inserting it in the holes to make sure they are not clogged.
Once all of the pieces are dried out you can reassemble the unit.
Store unit indoor in a dry environment till needed.
Page 6 | Page 11 |
