Roberts Gorden DF-Series Remote Panel Descriptions, Basic Remote, Standard Discharge Control

Remote Panel Descriptions

Basic Remote	Standard Discharge Control	Deluxe Temperature Control
	Remote (SDC)	Remote (DTC)
This control is used for make-up air	This control is used for make-up air and	This control is used for make-up air
and space heating. The discharge	day/night heating of the building. The	and total automatic “day/night” heating
temperature of the heater remains	discharge temperature of the heater	of the building. A solid-state modulat-
constant as selected on the selection	remains constant as selected on the	ing room Selectrastat fully modulates
dial. The burner flame is modulated	selection dial. The burner flame is	the burner flame to maintain space
by a discharge temperature control,	modulated by a discharge temperature	temperature and compensate for
which is governed by the remote	control, which is governed by the	changing building heat losses or
temperature selector.	remote temperature selector.	gains.
FAN ON/BURNER ON mode:	AUTO/WINTER mode:	AUTO/WINTER mode:
	Heater cycles on/off to maintain space	Occupied time: Heater can operate
Heater can operate continuously for
	temperature as selected on the	continuously fully modulating Btu/h
building exhaust air replacement and
	thermostat.	output to maintain space temperature
space heating by maintaining a
		as selected on the Selectrastat.
constant discharge temperature.
	ON/WINTER mode:	Unoccupied time: Heater cycles on/
FAN ON/BURNER OFF mode:	Heater can operate continuously for	off to maintain space temperature as
The blower can operate without the	building exhaust air replacement and	selected on the programmable ther-
	space heating by maintaining a constant	mostat
burner for summer ventilation.
	discharge temperature.	(night setback).
NEMA 1 enclosure.	ON/SUMMER mode:	ON/WINTER mode:
	The blower can operate without the	Heater can operate continuously fully
	burner for summer ventilation.	modulating Btu/h output to maintain
		space temperature as selected on the
	NEMA 1 enclosure.	Selectrastat.
		ON/SUMMER mode:
		The blower can operate without the
		burner for summer ventilation.
		NEMA 1 enclosure.

Installation Code and Annual Inspections:

All installations and service of ROBERTS GORDON® equipment must be performed by a contractor qualified in the installation and

service of equipment sold and supplied by Roberts-Gordon and conform to all requirements set forth in the ROBERTS GORDON® manuals and all applicable governmental authorities pertaining to the installation, service and operation of the equipment. To help facilitate optimum performance and safety, Roberts-Gordon recommends that a qualified contractor annually inspect your ROBERTS GORDON® equipment and perform service where necessary, using only replacement parts sold and supplied by Roberts-Gordon.

Further Information: Applications, engineering and detailed guidance on systems design, installation and equipment performance is available through ROBERTS GORDON® representatives. Please contact us for any further information you may require, including the Installation, Operation and Service Manual.

This product is not for residential use.

This document is intended to assist licensed professionals in the exercise of their professional judgement.

Roberts-Gordon, LLC	European Office:
1250 William Street	Roberts Gordon Europe Limited
P.O. Box 44	Telephone: +44 (0)121 506 7700
Buffalo, NY 14240-0044 USA	Fax: +44 (0)121 506 7701
Telephone: 716.852.4400
Fax: 716.852.0854
Toll Free: 800.828.7450
www.rg-inc.com
© 2008 Roberts-Gordon LLC	All rights reserved. No part of this work covered by the copyrights herein may be reproduced or copied in any form
	or by any means – graphic, electronic, or mechanical, including photocopying, recording, taping, or information
	storage and retrieval systems – without written permission of Roberts-Gordon LLC.

Printed in U.S.A. C2RPBNA 1008 Rev A