Installing your power supply

To make sure you connect your power supply correctly, check your motherboard and graphics card manuals for compatibility before connecting the RF-900WPS to any of your devices.

Notice: Cable management

This product uses color-coded sockets and cables for ease of use. Connect the plugs to only those sockets with the same color ends. Red and blue sockets are to be used for PCIe cables only. Black sockets are to be used for all other connections.

Warning: Failure to follow these instructions may result in damage to your computer components.

To install your power supply:

1Check your local AC voltage before installation (115 VAC voltage is for USA, Japan, and several others, and 230 VAC voltage is for Europe, Southeast Asia, and many other countries).

Caution: Make sure that you connect the power supply to local input AC voltage only. Setting the incorrect voltage can damage the power supply and connected equipment and may void your warranty. The RF-900WPS is compatible with 115 VAC and 230 VAC input voltage.

2Turn off your computer, then unplug the power cord from your old power supply.

3Open your computer case following the directions provided in your case manual.

4Disconnect all power supply connectors from the motherboard and peripheral devices such as case fans, hard drives, floppy drives and DVD and CD drives.

5Remove the old power supply from your computer case and install your new Rocketfish power supply.

6Connect the 20+4-pin main power connector to your motherboard.

RF-900WPS 7