Nintendo® DSi™ Starter Kit
Welcome
Congratulations on your purchase of another
Package contents
DC car adapter (1) | Screen shields (2) | Stylus (2) | Clear | ||
| Camera lens shield (2) |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Stylus lanyards (2) | Earbud headphones (1 set) | USB cable (1) | Quick Setup Guide (1) |
Using the USB car charger
1Connect the DC car adapter to your Nintendo DSi using the included USB cable. Make sure that both plugs are facing the correct direction
before you insert them into the connectors, or you may damage the connector’s pins.
Caution: Make sure that the plug is facing the correct direction before you connect it to your console, or you may damage the connector’s pins.
2 Insert the DC car adapter into a standard 12V DC car cigarette lighter or accessory socket. Make sure that the plug is fully inserted into the socket. The charge indicator LED on your console turns orange while recharging, then turns off when fully charged.
3When your console is fully charged, unplug the car charger and disconnect it from your game console. Make sure that you pull on the charger housing, not the power cord itself.
Applying the screen and camera shields
Shields provide a tough, durable, transparent surface, while keeping the LCD screens and camera lens clean and unscratched.
1Clean the screens before installing
the screen shields.
2Remove the adhesive backing from the screen shield and carefully attach it to the screen.
3Use any straight , rounded edge to smooth bubbles out of the shield
from one side to the other.
4Carefully attach the camera lens shield to the camera lenses on the interior and exterior of the DSi.
Installing the clear play-thru case
The
•Carefully slide your game console into the case.
Using the earbuds
With the earbud headphones, you can more easily hear game sounds, without disturbing others.
•Insert the earbud’s plug into the headphone connector on your console.
Warning: Make sure that the volume is turned down before connecting the earbuds. Otherwise, you may damage your hearing.
Using your stylus and lanyard
Your new stylus, with an attached lanyard, is perfect for replacing the original stylus, if it gets lost or damaged. The lanyard makes it easy to remove and hold onto the stylus.
To attach a lanyard to a stylus:
1Feed one end of the lanyard through the lanyard hole in the stylus.
2Feed the other end of the lanyard through the lanyard loop that was
fed through the hole, then pull to tighten.
90-day limited warranty
Visit www.rocketfishproducts.com.
© 2009 Best Buy Enterprise Services, Inc.
All rights reserved. ROCKETFISH is a trademark of Best Buy Enterprise Services, Inc. Registered in some countries. All other products and brand names are trademarks of their respective owners.
ENGLISH
QUICK SETUP GUIDE |