Thank you for purchasing this high quality Rocketfish product. Your Bluetooth speaker represents the
Charging your speakers fully for the first time
Bluetooth Speaker for iPad 2
RF-TRSPIPAD
Plug the small end of the included USB cable into the speakers and the other end into an available USB port on your computer. It takes approximately four to five hours to fully charge your speakers.
Note: You can charge your speakers and listen to audio at the same time.
Charging in | Full Charge indicator |
Progress indicator | (Constant green LED) |
(Red blinking LED) |
|
Note: Speakers will work with most Bluetooth audio devices.
QUICK SETUP GUIDE
Installing the speaker unit into the Smart Cover
Place the highlighted areas of the speaker unit and the Smart Cover together in the orientation illustrated in Step 1, then proceed with the rest of the steps.
Speaker unit
Smart Cover
Turning on and pairing your devices
Turn on the speakers by pushing in on the side with the power on icon. This should turn on the unit and automatically put it in pairing mode. (Repeat the action on the opposite side to pop out the other speaker for better audio quality.)
Established connection (Green LED)
To pair with your iPad:
From the Home screen, choose Settings > General > Bluetooth and turn Bluetooth on.
iPad searches for nearby Bluetooth accessories.
Choose and Accept the Bluetooth accessory. This device is identified as
If needed, please refer to your iPad manual for additional pairing information.
LED is Constant Green if connection is established with iPad 2.