RocketFish RF-TVMFM03 manual Install the TV brackets, Add the horizontal bars, Package contents

RF-TVMFM03_10-0726_QSG_V2_EN.eps 1 7/2/2010 1:18:59 PM

QUICK SETUP GUIDE

RF-TVMFM03

Note: Intended for use on wood stud walls with 16 in. or less spacing only.

1 Install the TV brackets

Option 1: Installing for a flat mounting surface

1Align the TV brackets (A and B) with the screw holes on the back of the TV.

2Place the M4/M5 washers (H) or M6/M8 washers (O) over the holes in the TV brackets that align with the screw holes on the back of the TV, then insert the M4 screws (F), M5 screws (J),

M6 screws (L or M), or M8 screws (Q) through the washers.

3Tighten the screws until they are snug against the TV bracket. Do not over tighten.

2 Add the horizontal bars

1Slide the horizontal bars (C) through the wire guides on the TV brackets.

2Secure the bars to the TV brackets using the 9/16 in. × 8/32 in. Phillips head screws (W).

C

M

Y

CM

MY

CY

CMY

K

Thank you for choosing the Rocketfish RF-TVMFM03. The RF-TVMFM03 TV mount is designed to support a flat-panel TV weighing up to 130 lbs. (58.9 kg).

Package contents

A Right vertical TV bracket (1)							M8 bag
B Left vertical TV bracket (1)							Q M8 × 16 mm screws (4)
C		Horizontal TV bracket (2)					R M8 × 40 mm screws (4)
D		Arm assembly (1)					S M8 × 60 mm screws (4)
E		Wall plate (1)					Hex key bag
M4 bag							T 3/16 in. hex key (1)
F M4 × 12 mm screws (4)							Lag bolt bag
G M4 × 30 mm screws (4)							U Lag bolt washer (4)
H		M4/M5 washers (8)					V 5/16 in. × 2-3/4 in. lag bolt (4)
I		M4/M5 spacers (4)					Bracket hardware
M5 bag							W 9/16 in. × 8/32 in. Phillips head screw (4)
J M5 × 12 mm screws (4)							X 3/8 in. × 8/32 in. Phillips head screw (1)
K M5 × 30 mm screws (4)							Cable ties
M6 bag							Y 8 in. nylon cable ties (5)
L M6 × 12 mm screws (4)							Cap screws
M M6 × 20 mm screws (4)							Z 5/32 in. hex key (1)
N M6 × 35 mm screws (4)							AA Cap screws (2)
O		M6/M8 washers (4)
P		M6/M8 spacers (4)				A	B		C
M4 bag			F		G
		M4 × 12 mm		M4 × 30 mm
			H		I
			M4/M5		M4/M5
M5 bag			J		K				D	E
		M5 × 12 mm		M5 × 30 mm
M6 bag			L	M			N	O	P
		M6 × 12 mm		M6 × 20 mm		M6 × 35 mm		M6/M8	M6/M8	Bracket hardware
M8 bag				Q		R			S	W	X
			M8 × 16 mm		M8 × 40 mm			M8 × 60 mm
Hex key bag								Cable ties		Y
						T
				3/16 in.
				U		V			Cap screws with hex key
Lag bolt bag											Z
						5/16 in. × 2-3/4 in.			5/32 in.		AA
	Tools you will need:
	•		Stud finder			•	Socket wrench with
	•		Awl				1/2 in. socket or
	•		Pencil				adjustable wrench
	•		Level			•	7/32 in. wood drill bit
	•		Tape measure			•	Power drill
	•		Phillips screwdriver

R

or

or

Option 2: Installing for an obstructed mounting surface

Note: Use additional washers (H) with M4/M5 hardware only.

1Place the M4/M5 spacers (I) or M6/M8 spacers (P) and the M4/M5 washers (H) into the recessed screw holes on the back of the TV.

2Align the TV brackets (A and B) with the spacers and washers on the back of the TV.

3Place the M4/M5 washers (H) or M6/M8 washers (O) over the holes in the TV brackets that

align with the screw holes on the back of the TV, then insert the M4 screws (G), M5 screws (K), M6 screws (N), or M8 screws (R or S) through the washers.

4Tighten the screws until they are snug against the TV bracket. Do not over tighten.

or

or

or

3 Install the wall plate to a wood stud wall

Note: Any material covering the wall must not exceed 5/8 in. (16 mm).

1Locate the studs. Verify the center of the stud with an awl or thin nail or use an edge-to-edge stud finder.

2	Level the wall plate (E) and mark the hole locations.	<5/8 in.
			16 in.
3	Drill pilot hole to a depth of 3 in. using a 7/32 in. diameter drill bit.

4Align the wall plate (E) with the pilot holes.

5Place the washers (U) over the holes in the wall plate (E), insert the lag bolts (V) through the washers, then tighten the lag bolts only until the washers (U) are pulled firmly against the wall plate.

CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten

the lag bolts (V).

	Wall
10-1/5 in.	7 in.	(75 mm)
	TV	3 in.

TV shifts 7 in. from the home position to full extension.