Symptom | Diagnosis | Remedy |
|
|
|
|
|
Speaker Output | Input gain signal for | Readjust input gains of |
|
Low or Distorted | amplifier is incorrectly | amplifier. |
|
| set. |
|
|
|
|
|
|
| Source unit output too | Check system with known |
|
| low or source unit has | working source and repair |
|
| no output. | or replace original source |
|
|
| as needed. |
|
|
|
|
|
| XCard is missing or not | Check XCard position and |
|
| placed properly in cross- | repair or replace as neces- |
|
| over slots. | sary. |
|
|
|
|
|
| Low battery voltage or | Check the alternator, bat- |
|
| large voltage drops to | tery, fuse, and power and |
|
| the amplifier under load. | ground wiring. Repair as |
|
|
| necessary. |
|
|
|
|
|
Amplifier Noise | Voltage spike from out- | Disconnect input signal to |
|
put of preceding com- | amplifier and turn ampli- |
| |
ponent is entering am- | fier on and off. If noise is |
| |
|
| ||
| plifier through input sig- | eliminated, connect REM |
|
| nal. | lead of amplifier to source |
|
|
| unit with a delay |
|
|
| module. |
|
|
|
|
|
| Voltage spike from re- | Use a different 12 volt |
|
| mote | source for REM lead of |
|
| entering through REM | amplifier. (i.e., battery di- |
|
| input terminal. | rect) If noise is eliminated, |
|
|
| use a relay to isolate am- |
|
|
| plifier from noisy |
|
|
| output. |
|