Rockford Fosgate 500.2 manual Specifications, Watts

500.2 SPECIFICATIONS

Dynamic Power Rating (IHF-202 Standard) - Measured at 14.4V Per channel into a 4Ω load

Per channel into a 2Ω load Bridged into a 4Ω load

Continuous Power Rating (Competition Standard) - Measured at 13.8 Battery Volts RMS continuous power per channel, both channels driven

into a 4Ω load from 20 to 20,000Hz with less than 0.05% THD (Total Harmonic Distortion)

RMS continuous power per channel, both channels driven into a 2Ω load from 20-20,000Hz, with less than 0.10% THD

RMS continuous power mono, into 4Ω load from 20-20,000Hz, with less than 0.10% THD

Common Mode Rejection Ratio (CMRR):

Signal-to-Noise Ratio:

Frequency Response:

Bandwidth:

Damping Factor @ 4Ω (at output connector):

Slew Rate:

IM Distortion (IHF):

Input Impedance:

Source Unit Compatibility (+15dB gain overlap):

Input Sensitivity (+0dB gain overlap):

Pass-Thru Output:

B+ Fuse Size: (External to amplifier)

Fuse Type:

Crossover Slope:

Factory Crossover Frequency:

Factory Default Crossover Setting:

Dimensions: (including end caps)

450Watts

730Watts

1460 Watts*

250Watts

500Watts

1000 Watts

Typically 40dB

>100dB (A-weighted)

20Hz-20,000Hz ±0.5dB

10Hz–250kHz ±3dB

>200

50V μs

<0.05%

20k Ohms

34V max.

Variable from 350mV to 6V

Unity Gain

100 Amp or two 50 Amp

(1) ANL / (2) AGU

12dB or 24dB/octave Butterworth

80Hz (0.047μf)

Full Range

9-5/8"W x 18-9/32"L x 2-5/8"H (24.4cm) x (46.43cm) x (6.6cm)

*This is the calculated Dynamic Power Rating. Actual output power exceeded the input capability of the PowerCube.

Specifications subject to change without notice.

– 28 –