| O P E R A T I O N | C a s p i a n FM Tuner |
|
|
|
Please refer to the front and rear panel views on page 4.
SWITCHING ON
The Mains power switch (6) is located on the rear panel of the FM Tuner. This switch should be left ON for normal operation. If unattended for a long period, the Mains power should be switched OFF and the lead disconnected from the power supply.
Switch the tuner ON using the rear panel switch.
Your tuner will run a
MODE SWITCH
To bring the Caspian out of STANDBY
Press the MODE switch.
The MODE indicator will glow GREEN. Your tuner is now operational.
The tuner may also be brought out of STANDBY by clicking the CHANNEL knob one position to the right or left.
To switch the Caspian back into STANDBY
Press the MODE switch again with a sustained press. The MODE indicator will change back from green to red as the tuner enters STANDBY.
When you activate the tuner after switching on at the rear panel, the tuner will
AUTOMATIC TUNING
Spin the TUNE knob clockwise. The tuner will rapidly scan up the band. Spin the knob anticlockwise to tune down the band.
When a station is detected, the frequency is displayed and the scan stops The Signal Display will lock, centralise the station and indicate the signal strength.
You may now store this station in a preset (See Page 7) Spin the TUNE knob again to repeat the procedure.
To stop an automatic scan
Slightly move the TUNE knob in the direction opposite to the scan i.e. if the tuner is scanning up the band an anticlockwise rotation will halt the scan.
The autoscan may also be stopped by clicking the CHANNEL knob one position to the right or left.
MANUAL TUNING
Rotate the TUNE knob to manually alter the frequency in 10 kHz steps and fine tune the station.
Roksan Audio ltd | Caspian FM Tuner User Manual |
CLASSIFICATION: General Use | Version 3.01 |
All specifications are liable to change without notice. E&OE | Page 6 of 11 | ENGLISH |
