Roland AC-33 Producing Sound

Português Italiano DeutschNederlands Español Français English

Once the connections have been completed, turn on power to your

various devices in the order speci ed. By turning on devices in the

wrong order, you risk causing malfunction and/or damage to speakers

and other devices.

1. Make sure that the power to all equipment is turned o .

2. Connect your external equipment.

3. Set each of the AC-33’s [VOLUME] knobs and the [MASTER]

knob to 0.

4. Switch on the power to any external equipment connected

to the AUX IN jacks.

5. Switch on the AC-33’s power.

6. Switch on any equipment connected to the LINE OUT jack.

To turn the power o , reverse these steps.

NOTE

• To prevent malfunction and/or damage to speakers or other

devices, always turn down the volume, and turn o the power on

all devices before making any connections.

• This unit is equipped with a protection circuit. A brief interval (a

few seconds) after power up is required before the unit will operate

normally.

• Always make sure to have the volume level turned down before

switching on power. Even with the volume all the way down, you

may still hear some sound when the power is switched on, but this

is normal, and does not indicate a malfunction.

• If you’re operating the AC-33 only on batteries, the POWER indicator

will become dim as the batteries run low.

When the batteries run even lower, the POWER indicator will blink.

Replace the batteries as soon as possible.

1. Connect your guitar, and switch on the AC-33’s power.

Connect your guitar to the INPUT jack of the GUITAR CHANNEL.

Any guitar that has a pickup can be connected.

If your guitar has a pickup as well as a built-in preamp, you can also

connect it to the MIC/LINE CHANNEL.

2. Set the [VOLUME] knob of the input you’re using to the 5

position (center).

3. While producing sound, use the [MASTER] knob to adjust the

volume.

1. Use the [BASS] (low range), [MIDDLE] (mid range), and

[TREBLE] (high range) knobs of the desired channel to adjust

the tone.

Producing Sound