16

Convenient Features

Using a speaker stand (Option: ST-A95)

By using a speaker stand (Option: ST-A95), you can mount the BA-330 at the optimal height for use as a monitor speaker or simple PA device.

Attachment procedure

Always have at least one other person assist you when
mounting the BA-330 on a speaker stand, or when adjusting the
height of the stand while the BA-330 remains mounted on it.
Be careful not to pinch your ngers, when you assemble.
Upper tube
Tripod knob
Height adjustment knob
Stopper
Tripod

Loosen tripod knob and open the tripod.

After opening the tripod, tighten the tripod knob again.
The distance between lower ends of the tripod should be 98cm
as shown in gures on the below. If the tripod is not opened wide
enough, the stand may be unstable.
Leg spread: 98 cm or
more (38-5/8”)
Diameter:
112 cm or more
(44-1/8”)

Loosen height adjustment knob and make upper tube

longer.

Set up upper tube at the required height and insert the

stopper into the hole in upper tube (refer to following

gure).

Stopper
Use the ST-A95 only with the stopper inserted into upper tube.

Tighten height adjustment knob.

Fit the hole on the BA-330 onto upper tube.

1.
*
2.
3.
*
4.
5.
WARNING
The BA-330 is designed to be used in combination with the speaker
stand manufactured by Roland (ST-A95). Please do not use any
other stands.
Before use, adjust the speaker stand to a height of 130 cm (51-3/16”)
or less and a leg spread of 98 cm (38-5/8”) or more, as shown in the
gure below.
130 cm or less
(51-3/16”)
98 cm or more (38-5/8”)
Using a speaker stand that does not meet the specications at left
or that is adjusted to a height over 130 cm (51-3/16”), or a leg spread
of less than 98 cm (38-5/8”) may result in damage to equipment or
injury due to the stand tipping over.
When using BA-330 with a speaker stand, the speaker stand must be
carefully placed so it is level and sure to remain stable.
Cables connected to BA-330 should be given enough slack to pre-
vent accidents that might result from someone tripping over them.
To prevent accidents due to falls, do not place any object on the
BA-330 when it’s mounted on a speaker stand.
•
•
•
•
•
•