9
5.
Put the Pedal Board on the stabilizer.
When putting the Pedal Board on the stabilizer, first
loosen the attachment screws securing the speaker box
to the side boards.
fig.st5.e
6.
Secure the Pedal Board to the side boards with the
attachment screws (in two places).
Re-tighten the screws loosened in Step 5.
fig.st6.e
To stabilize the pedals
Temporarily loosen the screws that fasten the pedal board.
Step on the pedal, and after verifying that the pedal is in firm
contact with the floor, re-tighten the attachment screws firmly.
7.
Align the protruding screws (one each at right and
left) on the bottom of the piano with the openings in
the metal fittings on the side board, then slide the
piano forward until the screws are held in place.
* When handling the piano, firmly grasp it at the front and
back. Be careful, so you do not get your fingers pinched.
Place the keyboard so that it is centered, both front to
back and left to right.
8.
Fasten the piano to the stand with the attachment
screw (one each for the right and left).
fig.st7.e
9.
Connect the speaker cord extending from the rear of
the speaker box to the DP-970’s speaker connector.
Press the speaker cord completely into the connector so
that it is securely fastened.
fig.st8.e
* Use the speaker cable with the ferrite core left attached to the
cable. The DP-970 cannot be used with the ferrite core
removed.
10.
Connect the pedal cords to the Pedal jack.
11.
As necessary, affix cord clamps as shown in the
diagram to fasten the pedal cord.
fig.st9.e
When Moving the Instrument
Disconnect the AC cord and cables from the DP-970.
Then lift the piano while keeping it level, and move it
with care, so that you do not drop it on your feet, or get
your hands caught.
Check the stability of the pedal, and make adjustments
as necessary.
When Disassembling
Disassemble the unit by carrying out assembly Steps 1-
11 in reverse order.
When Changing the Orientation of the Speaker Box
Be sure to completely disassemble the unit, change the
speaker box orientation, then reassemble it.
Pedal Board
Metal Parts
Pedal Board
Putting the
Pedal Board
(a lateral view)
Loosen the screws
(in four places).
Attachment
screws
7
8
Please don’t get
your fingers pinched
Attachment
Screw
DP-970 Rear
Hold and insert the cable so that
the clip portion extends into the
stand and is securely connected.
Speaker Connecter
Speaker cable
Clip Portion Ferrite
Core
Cord
Clamps
Pedal Cord
Power Cord
Speaker Cord
DP-970_e.book 9 ページ ２００７年１月１６日　火曜日　午後１時４２分