38

Connecting External Devices

Connecting MIDI Devices

By connecting an external MIDI device and exchanging
performance data, you can control the performances on one
device from the other. For instance, you can output sound from
the other instrument or switch tones on the other instrument.

■

What’s MIDI?

MIDI stands for Musical Instrument Digital Interface, an
international standard which allows performance information
to be communicated among electronic musical instruments and
computers.
The HP201 provides MIDI connectors, which allow
performance data to be exchanged with external devices.
When these connectors are used to connect the HP201 to
external devices, an even wider range of possibilities becomes
available.

Connection Examples

NOTE

To prevent malfunction and/or damage to speakers or
other devices, always turn down the volume, and turn off
the power on all devices before making any connections.

Playing the HP201 from a MIDI sequencer/Recording an

HP201 performance on a MIDI sequencer

fig.midi2.e

Set Local Off if you have connected the HP201 to a MIDI
sequencer. Refer to “Switching Local Control On and Off”
(p. 39). Also set your MIDI sequencer to MIDI Thru mode
(so that messages received at MIDI IN will be re-
transmitted without change from MIDI OUT). For details,
refer to the owner’s manual of your MIDI sequencer.

Perform on the HP201 to play a MIDI sound module

fig.midi1.e

■

MIDI Send Channel Settings

MIDI features sixteen MIDI channels, numbered 1–16. Simply
connecting a cable is not enough for communication to take
place. The connected devices must be set to use the same MIDI
channels. Otherwise, no sound will be produced, and no
sounds can be selected.
* The HP201 receives all channels 1–16.

When you’re using Dual Play (p. 17) on the HP201, the
notes for “Tone 2” are transmitted on channel 5. This MIDI
transmit channel setting is fixed. If you’re using Dual Play
with an external MIDI device connected, set your device
to a channel other than channel 5.
When the HP201 is turned on, Channel “1” is selected.

1.

While holding down the [METRONOME] and

[REVERB/KEY TOUCH] buttons, press the

appropriate key (C6–E 7) on the keyboard.

The MIDI transmit channel will switch to the number that
corresponds to the note you pressed.
MIDI Out/In
Connector
MIDI Sequencer
MIDI Cable
OUT MIDI IN
MIDI Out/In
Connectors
MIDI Sound Module
MIDI Cable
THRU OUT
MIDI IN
724 911 1416
81 3 5 6 10 12 13 15
C6 C8
HP201_e.book 38ページ ２００７年２月２８日　水曜日　午前９時１０分