5
Setup
Assembling the KD-120
1.
Place the KD-120 pad, with the head surface facing downward, on a flat surface such as the
floor.
2.
Use the included drum key to loosen and remove the bolts for the brackets on the back of
the KD-120 pad.
3.
Mount the stand on the brackets so that the output jack for the KD-120 pad faces up.
Use the bolts you removed earlier to secure the KD-120 pad to the stand, tightening the
bolts with the included drum key.
* Take care not to pinch your fingers between the KD-120 pad and the stand plate.
4.
Adjust the ends of the legs to match the location where you’re installing the KD-120.
Adjust to use the spike legs when installing on carpeting or other soft surfaces, or the
rubber legs when installing on flooring or other hard surfaces.
When shipped from the factory, the stand is adjusted for using the rubber legs. If you’re
using the rubber legs, proceed to step 5 on the next page.
Output jack
Bracket
Adjusting for the Spike Legs
1. Loosen the leg nut.
2. Turn the rubber foot to adjust so that the spike portion sticks out
from the rubber foot. Adjust the length of the spike to suit the
location where installing and the length you prefer.
* The tip of the spike is sharp. Handle it with care.
3. Tighten the nut to secure the rubber foot in place and keep it
from loosening.
* When using on flooring, the spike legs may damage the floor. Adjust to use the rubber legs.
Adjusting for the Rubber Legs
1. Loosen the leg nut.
2. Turn the rubber foot to adjust so that the spike portion does not
stick out from the rubber foot.
3. Tighten the nut to secure the rubber foot in place and keep it
from loosening.
Nut
Rubber foot
Spike
Nut
Rubber foot
KD-120.e.book 5 ページ ２００５年１２月８日 木曜日 午後３時３５分