15
Operating the RE-20
2.
Release the TAP pedal.
The pitch of the oscillating sound starts to fall, and the original echo sound returns.
The TAP indicator lights when the twist effect is finished.
* Once the TAP pedal is released, changing the repeat rate or intensity cancels the twist effect. The
setting is then changed to the value set with the knob or expression pedal.
* Adjusting the MODE SELECTOR knob while the twist effect is being applied cancels the twist effect.
* You can apply the twist effect with an external expression pedal. For more detailed information, refer to
“Control Using an Expression Pedal” (p. 16).
Switching the Repeat Rate and Delay Time Mode
The RE-20 features two modes to select from.
Normal mode:
The REPEAT RATE knob functions over the same range as the
RE-201. Additionally, the maximum value that can be set for
the tap delay time is three seconds (when the MODE
SELECTOR knob is set to the 3 or 7 position).
Long mode:
The range for the REPEAT RATE knob setting is expanded to
twice the normal setting. Additionally, the maximum value
that can be set for the tap delay time is six seconds (when the
MODE SELECTOR knob is set to the 3 or 7 position).
1.
Turn off the RE-20.
* Disconnecting the plug from the INPUT A/MONO jack switches off the power.
2.
While holding down the TAP pedal, turn on the power to the RE-20.
The virtual tape display flashes, and then remains lit.
* Connecting the plug to the INPUT A/MONO jack switches on the power.
3.
Confirm that the virtual tape display is lit, then release the TAP pedal.
4.
Turn the MODE SELECTOR knob to select the mode.
5.
Press the TAP pedal.
The TAP indicator flashes rapidly, and the setting is saved to the RE-20’s memory.
When the setting is saved, the TAP indicator remains lit, and the RE-20 returns to its
normal operating status.
* Be sure not to turn off the power while the TAP indicator is flashing rapidly.
* This setting is saved even after the power is turned off.
* When the RE-20 is set to Long mode, the EFFECT ON/OFF indicator and TAP indicator flash rapidly
immediately after the power is turned on.
* The default factory setting is Normal mode.
MODE
SELECTOR Mode
1
Normal mode
2
Long mode
RE-20_e.book 15 ページ ２００７年６月８日　金曜日　午後４時３２分