Roland SP-303 Loading Sample from a Memory Card (Sample Load)

50
Chapter 6. Using Memory Cards
Never turn off the power while the dots are blinking.
This may result in damage to the memory card and
corruption of data in the internal memory.
Loading Sample from a
Memory Card (Sample Load)
You can load the collected data for one set (of sixteen
samples) saved to a memory card, replacing the data in the
SP-303’s internal memory (Sample Banks A and B). This
operation is called Sample Load.
When this operation is performed, the internal data of
the SP-303 will be overwritten. Be sure to make a backup
of important data before you do this.
fig.r06-06
1. Confirm that [PATTERN SELECT] is not lit.
If [PATTERN SELECT] is lit, press it so that the button’s
light goes out.
* Take care to note that if [PATTERN SELECT] is lit, the SP-
303 will then proceed with the Pattern Load operation.
2. Hold down [CANCEL] and press either BANK [A] or