40

Chapter 6. Using a Memory Card

Here’s how to save backup data (all of the SP-404’s data including
sample banks and pattern banks) to a memory card. You can save up
to twelve sets of backup data.
If the card runs out of free space because you save large
amounts of sample or pattern data, the number of backup sets
that can be saved will be fewer.
1.
Hold down [CANCEL] and press one of the BANK [C/G]–[F/
J] buttons.
“SAV” appears in the display and pads for which backup data
has not been saved begin blinking.
2.
Select a backup-destination pad.
The selected pad lights, and the other pads stop blinking. [REC]
begins blinking.
You can’t select a pad that was dark in step
1
(i.e., a pad for
which data has already been saved).
If you decide to cancel the operation at this point, press
[CANCEL].
3.
Press [REC].
[REC] lights, and the Backup Save operation begins. The dot in
the display will blink while the operation is in progress. When
saving is complete, the blinking will stop.
Never turn off the power while the dot is blinking. Doing so
may damage the backup data or the memory card.
Here’s how to load backup data (all of the SP-404’s data including
sample banks and pattern banks) from a memory card.
When you execute the Backup Load operation, the internal
settings of the SP-404 will be erased and replaced by the backup
data you loaded.
1.
Hold down [CANCEL] and press BANK [A] or [B].
“Lod” appears in the display and the pads for which backup
data has been saved begin blinking.
If the Protect setting (p. 43) is enabled, “Prt” (Protected) appears
in the display, and you will be unable to execute the Backup
Load operation.
2.
Press a pad to select the backup data that you want to load.
The selected pad lights, and the other pads stop blinking. [REC]
begins blinking.
You can’t select a pad that was dark in step
1
(i.e., a pad for
which no data has been saved).
If you decide to cancel the operation at this point, press
[CANCEL].
3.
Press [REC].
[REC] lights, and the Backup Load operation begins. The dot in
the display will blink while the operation is in progress. When
loading is complete, the blinking will stop.
Never turn off the power while the dot is blinking. Doing so
may damage the backup data or the memory card.
Here’s how to delete unwanted backup data (containing all of the
SP-404’s data including sample banks and pattern banks) from a
memory card.
1.
Hold down [DEL] and press one of the BANK [C/G]–[F/J]
buttons.
“bdL” appears in the display and the pads for which backup
data has been saved begin blinking.
2.
Press a pad to select the backup data that you want to
delete.
The selected pad lights, and the other pads stop blinking. [DEL]
begins blinking.
You can’t select a pad that was dark in step
1
(i.e., a pad for
which no data has been saved).
If you decide to cancel the operation at this point, press
[CANCEL].
3.
Press [DEL].
[DEL] lights, and the Backup Delete operation begins. The dot
in the display will blink while the operation is in progress.
When the Backup Delete operation is complete, the blinking
will stop.
Never turn off the power while the dot is blinking. Doing so
may damage the backup data or the memory card.
Saving Backup Data (Backup Save)Loading Backup Data (Backup Load)Deleting Backup Data (Backup Delete)
SP-404_e.book 40ページ ２００６年３月３日　金曜日　午後２時４６分