9
KD-120 (V-Kick Trigger Pad)
The head tension of the KD-120 can be adjusted.
Use the included tuning key to adjust the tension.
In general, a tension that produces a strike response approximately the same as an acoustic bass drum will be appropriate.
* Head tension that is too loose may not only cause incorrect operation, but may even damage the sensor.
fig.14.e
1.
Check the current tension of the head.
2.
Remove the kick pedal from the KD-120.
3.
Loosen the lock nuts on the tuning bolts.
4.
Adjust bolt ‘a’ in the above diagram. Rotate it clockwise to tighten the head tension, or slightly
counterclockwise to loosen the tension.
* Fully tightening a tuning bolt at only a single location produces uneven tensioning, which may make it impossible to obtain the proper
strike sensitivity and may even result in incorrect operation. Be sure to tighten each tuning bolt a little at a time, as described in the above
explanation.
5.
Adjust bolt ‘b’ so that the tension is the same as the tension of ‘a’.
6.
Next adjust ‘c’ and ‘d’, and ‘e’ and ‘f’ in the same way.
7.
Make sure that the head tension is even, and repeat steps 5 and 6 if you wish to make further
adjustments.
* On the KD-120, adjusting the head tension affects only the head response, and does not change the pitch of the sound as it would on an
acoustic drum. To adjust the pitch, edit the sound parameters of the TD-20. For details refer to the TD-20 owner’s manual.
* The head tension will change as the instrument is used, so you should readjust when necessary.
8.
Tighten the lock nuts to prevent loosening of the tuning bolts.
9.
Mount the kick pedal on the KD-120.
Head Adjustment
Adjusting the Head Tension
acdbefHEAD MADE BY REMO U.S.A.
loosen
tighten
Lock nut
TD-20K_e.book 9 ページ ２００６年１２月７日 木曜日 午前９時２４分