4

Assemble the Drum Stand.

About the Stand, refer to the MDS-20 Owner’s Manual.
• Do NOT open the legs of the stand more than 135
degrees. The distance between the back Right/Left end
legs should NOT be more than 2 m (80 inches), otherwise,
the cable (inside the Pipes) could be damaged and/or the
stand could tip over.

fig.01.e

• Do NOT loosen any bolts other than Hand Knobs except
when changing the parts or cables for repairing.
Attach the stand holder (included with the drum stand MDS-
20) to the TD-20.
Using the screws attached to the bottom panel, attach the
holder so the unit is oriented as shown in the diagram.

fig.02.e

• To attach the stand holder, remove the four 12 mm
screws (M5 x 12) from the bottom of the TD-20 and use
them. Use of other screws may result in damage to the
unit.

928

• When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons
and controls. Also, you should try to orient the unit so no
buttons or controls get damaged.

929

• When turning the unit upside-down, handle with care to
avoid dropping it, or allowing it to fall or tip over.
Mount the VH-12 on a commercially available hi-hat stand.

Refer to the VH-12 Owner’s Manual.
After the VH-12 is connected to the TD-20 percussion sound
module, the

offset

must be adjusted. For details, read the
instructions in the TD-20 and VH-12 Owner’s Manuals.

MDS-20

(Drum Stand)

Caution in Setting Up the Stand

135˚ 135˚
2 m

TD-20

(Percussion Sound Module)

VH-12

(V-Hi-Hat)

Narrow
Wide
TD-20K_e.book 4 ページ 2006年12月7日 木曜日 午前9時24分