![](/images/backgrounds/246261/bgc.png)
10
Getting Ready to Play
* Once connections have been made (p. 9), turn on the power to the connected equipment in the order specified. Doing it in the wrong
order raises the risk of damage/malfunction to that equipment.
fig.P-PowerOn.eps
1. Turn the [VOLUME] knob all the way to the left.
2. Minimize the volume of the connected amp or
audio system.
3. Press the [POWER] button.
* Even with the volume all the way down, you may still hear
some sound when the power is switched on, but this is
normal, and does not indicate a malfunction.
* The TD-4 is equipped with a protection circuit and requires a
brief interval a few seconds) after powering before it will
operate normally.
4. Power-on the connected amp or audio system.
5. While hitting a pad, gradually turn the [VOLUME]
knob toward the right to adjust the volume.
Adjust the volume of the connected amp/ audio system to
the desired level.
Turning the Power Off
1. Turn the volume down on the TD-4 and any
connected equipment.
2. Power-off the connected equipment.
3. Hold down the [POWER] button until the display
indicates “See you!”
The TD-4 does not have a specific “operation” for saving your
settings. Any changes you’ve made will be saved when you turn
off the power.
* You must turn off the power by pressing the [POWER] button.
Turning the Power On/Off1
3
Caution when Turning On the Power
After you turn on the power, do NOT touch any pads or
pedals until the drum kit name (the illustration below) has
appeared in the display. Doing so can cause various
problems.
ig.d-OpenKitNo1.eps
Saving Your Settings
If you don’t hear any sound
Check the following points.
Pad and Pedal Connections
• Is the cable correctly connected to the TRIGGER INPUT
connector?
• Are the cables correctly connected to each pad or
pedal?
When Using an Amp or Audio System
• Are the TD-4’s OUTPUT jacks connected correctly to the
input jacks of your amp/audio system?
• Are the input selections and volume settings correct on
that amp/audio system?
• Possible problem with the connection cables
themselves?
• Isn’t the [VOLUME] knob turned all the way to the left?
• Have the input select settings of your audio system or
amp been made correctly?
• Is the amp or audio system volume setting correct?
When using headphones
• Are your headphones plugged into PHONES jack?
• Isn’t the [VOLUME] knob turned all the way to the left?
TD-4_e.book 10 ページ 2008年11月5日 水曜日 午後6時40分