Roland TDA-700 Connect your TDA-700

Connect your TDA-700

Refer to the following diagram and connect the TDA-700 to the external equipment you are using.

fig.30-1

* To prevent malfunction and/or damage to speakers or other

devices, always turn down the volume, and turn off the power

on all devices before making any connections.

* The pin assignment for the XLR type connectors is as shown

below. Before making any connections, make sure that this pin

assignment is compatible with that of all your other devices.

fig.31

Once the connections have been completed, turn on power to

your various devices in the order specified. By turning on

devices in the wrong order, you risk causing malfunction

and/or damage to speakers and other devices.

Switch on the power to the V-Drums sound module and

any equipment connected to CH 1–3.

TDA-700

If a mixer is connected to the

LINE OUT

jack(s) on the

TDA-700, turn on the mixer.

* This unit is equipped with a protection circuit. A brief interval

(a few seconds) after power up is required before the unit will

operate normally.

* Always make sure to have the volume level turned down before

switching on/off power. Even with the volume all the way down,

you may still hear some sound when the power is switched on/

off, but this is normal, and does not indicate a malfunction.

Mixer Percussion Pad

V-Drums Sound Module

Stereo

Headphones

Recorder

(Front Panel)(Rear Panel)

PHONESMASTER

Q:The volume level of the instrument connected to CH-

1–3 is too low.

A:Could you be using a connection cable that contains a

resistor?

Use a connection cable that does not contain a

resistor.