Rolls MX44S Introduction, Warranty Registration Description Rear Panel, TOP Panel, Front Panel

INTRODUCTION

Thank you for your purchase of the MX44s 4 Channel Stereo Mixer. This unit is designed to mix up to four stereo line-level signals such as instru- ments, CD players, DVD players, MP3 players, laptop computers, etc. to a single stereo output.

WARRANTY REGISTRATION

For complete warranty information, please visit our website at www.rolls. com and click on the "Register Your Warranty Here" text, and follow the link and instructions.

DESCRIPTION

REAR PANEL

OUTPUTS: 1/4" and 1/8' (3.5 mm)Tip-Ring-Sleeve jack for connection to a mixer input, amplifier or other input device.

ON/OFF: Latching push button switch for applying power to the MX44s.

12 VDC: Power jack - connects to the Rolls PS27 AC adapter.

BATTERY: Removable compartment for housing a 9 volt alkaline battery.

TOP PANEL

pwr: LED - Indicates that the MX44s is connected to a power source, and the unit is on.

1 - 4: Volume controls - adjust the level of the signals coming from Inputs 1 - 4.

FRONT PANEL

IN 1 - 4: 1/4" and 1/8" (3.5mm)Tip-Ring-Sleeve stereo unbalanced jacks for connection to line level devices.

Tip - Ring - Sleeve

Fig. 1

OPERATION

To connect various devices to the MX44s, you'll need the proper cables.

-Connecting most CD, Cassete, and Video units will require a stereo RCA to stereo 1/4" or 1/8" (3.5mm) cable. A stereo plug consists of tip, ring and sleeve connections - shown in Fig. 1.

-Most stereo instruments have individual Right and Left outputs. Therefore, you'll need an "Insert" type cable. This cable has two 1/4' TIp-Sleeve jacks on one end to connect to the stereo instrument, and a Tip-Ring-Sleeve stereo jack on the other end to connect to the MX44s. For assistance on cable selection, contact your local professional audio dealer.

-Some devices have stereo 1/4" outputs identical to the inputs of the MX44s. These devices will require a 1/4" TRS stereo to 1/4" or 1/8" TRS stereo cable.

NOTE: PLUGGING A TIP-SLEEVE MONO PLUG INTO THE MX44s WILL NOT DAMAGE THE UNIT. HOWEVER, THE SIGNAL WILL BE HEARD ON ONLY THE LEFT SIDE. DO NOT PLUG A MONO JACK INTO EITHER OUTPUT

- THIS WILL DAMAGE THE UNIT.

TO SEND A MONO SIGNAL TO THE MX44s, USE A TRS JACK WITH THE TIP AND RING CONNECTED TOGETHER.

While the MX44s is not a headphone amplifier, the outputs have sufficient level drive a pair of headphones or earphones for limited monitoring.

SCHEMATIC