Rolls RA62 owner manual Description, Connection

DESCRIPTION

FRONT PANEL

						PAN	HEADPHONE
OUT	OUT	OUT	OUT	OUT	OUT	INPUT
						STEREO
						PWR	AMPLIFIER
VOLUME	VOLUME	VOLUME	VOLUME		VOLUME	VOLUME	RA62

MONO

STEREO

Note: Descriptions for Channel One through Channel Six are identical.

OUT 1 - 6 : 1/4” Tip-Ring-Sleeve jack for connection to a standard pair of head- phones.

VOLUME 1 - 6: Controls the amount of output signal from the indicated channel.

MONO/STEREO SWITCH: When this switch is pressed in, the Right and Left channels are summed together providing a mono output signal.

PAN: Controls the relative amount of signal sent to the Right and Left output channels.

STEREO IN: 1/4” TRS input jack which paralells the rear panel Right and Left input jacks.

POWER LED: Indicates that the RA62 is connected to the power supply and is on.

REAR PANEL
	62-		MAIN INPUT		AUX INPUT
120 VAC										INSERT 2	INSERT 1
50/60 Hz 15 VA	SERIAL NUMBER		RIGHT	LEFT		INSERT 6	INSERT 5	INSERT 4	INSERT 3
	MODEL RA62	CAUTION			LEFT	RIGHT
		RISK OF ELECTRIC SHOCK
		DO NOT OPEN
	WARNING: DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.										NRTL /C
MADE IN U.S.A.	TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.			RISQUE DE CHOC - NE PAS ENLEVER
	NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

120 VAC INPUT: Connects to a properly grounded AC outlet.

MAIN INPUT: 1/4” TRS jacks for connecting to the desired Right and Left program material.

AUX INPUT: Additional 1/4” unbalanced inputs - for use in the event

Note: The description for the Channel Inserts pertains to all six channels.

CHANNEL INSERTS:

CONNECTION

Connect the AC cord to a properly grounded ac outlet.

Determine which input configuration you will use; either discreet right/left, TRS stereo, or mono.

For a discreet right/left input configuration, connect a 1/4” TS plug containing the “Right” portion of the stereo signal to the Right Main Input. Connect a 1/4” TS plug containing the “Left” portion of the stereo signal to the Left Input.

For a TRS stereo input configuration, connect a Tip-Ring-Sleeve stereo plug into the front panel STEREO IN input. This cable may come from a mixer’s headphone output for example.

To send a mono signal to the RA62, connect a 1/4” Tip-Sleeve plug into either the Right or Left input and press in the front panel MONO/STEREO switch. This mono signal will be fed to both the right and left sides of the headphone outputs.

The Aux Inputs are connected in the same manner as the discreet right/left input configuration listed above.

INSERTS

The inserts have been provided so you can directly access each headphone output with its own program material.

The inserts require Tip-Ring-Sleeve connectors, with right and left signals on the tip and ring respectively. If you use a TS mono plug - you will only hear sound out of one side.

When these insert jacks are used, the main Right/Stereo and Left/Mono, as well as the Aux Inputs - are disconnected. Only the stereo signals sent to the Insert jacks go to that corresponding output.

CAUTION: Plugging a mono 1/4” TS plug into the Headphone Outputs may cause permanent damage to the unit because one side would be shorted to ground. Never plug a mono plug into any of the Headphone Outputs.

Tip

Ring

Sleeve (ground)

3 4