SPECIFICATIONS

FM SECTION

 

Tuning Range:

87.5-108MHz

3 dB Limiting:

12dB

Image Rejection:

53dB

Usable sensitivity mono IHF :

9dB

Selectivity:

(-70KHz : +90KHz)

S/N Ratio at 1 mV Mono :

52dB

Stereo:

50dB

THD at 1 mV 40 kHz deviation:

0.18%

Stereo Separation:

28dB

Auto Scan Sensitivity:

23dB

AM Suppression Mod. :

52dB

Frequency Response:

3dB

Antenna Input Impedance:

75 Ohms

AM SECTION

 

Tuning Range:

522 - 1710 kHz (10 kHz increm.)

 

522 - 1611 kHz (9 kHz increm.)

IF Frequency:

450KHz

Usable Sensitivity:

28dB

Auto Scan Sensitivity:

41dB

S/N Ratio at 5 mV/M:

46dB

6 dB Bandwidth:

7KHz

Image Rejection:

42dB

A.C.A. +/- 9 kHz:

46dB

AGC Action:

43dB

THD at 5mV/M:

0.40%

Antenna Input Impedance:

300 Ohms

Size:

19" x 1.75" x 5"

 

(48.3 x 4.5 x 12 cm)

Weight:

7.1 lbs. (3.2 kg)

DESCRIPTION

FRONT PANEL

Station Call

M1 - M6: Directly accesses the preprogrammed station within the selected frequency band.

Band: Advances through the 2 AM and 3 FM bands.

A/PS: Advances through the station presets within the selected frequency band.

Ster/Mon: Selects between Stereo and Mono operation.

MUTE: Mutes all outputs.

Scan/Up: Increases the frequencies until a station strong enough to lock onto is reached. That station is played for approximately five seconds then scanning begins again. Scanning is continuous until a front panel button is pressed. The station the RS79 stops at will remain.

Seek/Up: Increases the frequencies until a station strong enough to lock onto is reached. That station will remain.

Tune +: Increases the tuner frequency by .1 MHz each time it is pressed.

Tune -: Decreases the tuner frequency by .1 MHz each time it is pressed.

LCD DISPLAY

A:Band indicator and number. There are three banks of FM and two banks of AM presets. NOTE: If the rear panel Frequency Select switch is set for 9kHz, the band will indicate MW 1 and MW2 instead of AM1 and AM2.

B:Stereo indicator. Indicates a locked signal and stereo operation. If this light is out, the unit is operating in mono or the station is weak.

C:Lock indicator - if lit the RS79b is locked onto a station.

D:Station frequency indicator

E:Indicates whether the station frequency is AM (KHz), or FM (MHz)

F:Preset number - 1 - 6.

G:IR - Infrared Remote sensor.

• Power Switch: Applies power to the RS79b.

IMPORTANT NOTICE: IF THE POWER IS TURNED OFF BY THE REMOTE, THIS FRONT PANEL POWER SWITCH IS INOPERABLE UNTIL THE

5

REMOTE IS USED TO TURN THE POWER BACK ON.

2

Page 3
Image 3
Rolls RS79b owner manual Specifications, Description