Roper FGP305K dimensions Freestanding Gas Range, Product Model Numbers, Overall Dimensions

®

30" Freestanding Gas Range

PRODUCT MODEL NUMBERS

FGP305K

Gas supply: Use 3/4" rigid pipe gas supply line to the range location. A smaller size pipe on long runs may result in insufficient gas supply. With L.P. gas, piping or tubing size can be 1/2" minimum. If local codes permit, it is recommended that new flexible metal tubing, design-certified by AGA or CSA, 1/2-inch or 3/4-inch I.D., be used for connecting the range to the rigid gas supply line. A 1/2" male pipe thread is needed for connection to pressure regulator female pipe threads. An individual manual shutoff valve must be located in the same room, but external to the range.

Electrical: A 120-volt, 60-Hz, AC-only,

10-ampere, electrical supply fused on both sides of the line. A separate circuit is recommended. A time-delay fuse or circuit breaker is recommended.

OVERALL DIMENSIONS

26-3/4" depth

with handle

36"

cooktop

height

46-1/4"

overall height for

tall backguard

models

24-1/4"

29-7/8" width

CABINET OPENING DIMENSIONS

18" min. clearance upper cabinet to countertop

This shaded area recommended for electrical outlet.

Contact a qualified floor covering installer to check that the floor covering can withstand at least 200°F.

Use an insulated pad or 1/4" plywood under range if installing range over carpeting.

13" max. upper cabinet depth

30" min. cabinet										For minimum
opening width
										clearance to top of
30-1/8"										cooktop, see Note.***
opening
width
	2" min. countertop
	space to side wall or
	other combustible
	material
								This shaded area
											Do Not seal the range to
								recommended
											the side cabinets.
								for installation
								of gas pipe.			If cabinet depth is greater
											than 24", oven frame
											must extend beyond
											cabinet fronts by 1/2"
											min.
		24"			10"
					8"
					5"
				2"		*** Note: 24" min. when bottom of wood or metal cabinet is
			5"
3"									protected by not less than 1/4" flame retardant millboard covered

with not less than No. 28 MSG sheet steel, 0.015"stainless steel, 0.024" aluminum or 0.020" copper.

30" min. clearance between the top of the cooking platform and the bottom of an unprotected wood or metal cabinet.

Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation	Ref. 98014964
Instructions packed with product. Specifications subject to change without notice.	02-25-04