IR REMOTE CONTROL BENDER R-W320-T User Manual
5
5. Installation/Operation Application 1: Use with IR bender only
z Insert the plug of the IR probes [F] into the IR probes output connection [B]
at the back of the IR bender [A].
z Install the IR bender flat on a horizontal surface within sight and reach of
your remote control (± 6m in ideal circumstances).
z Lead the IR probes inside the cabinet and to the A/V equipment in such
way that a LED can be stuck onto the IR eye of each A/V apparatus. Test
the position of each LED first before sticking as this should be done
carefully and precisely.
z Insert the plug of the PSU into the PSU input connection [D] at the back of
the IR bender. Only use the supplied PSU. Connect the PSU to the mains.
z Use your remote control and point towards the IR bender within an angle
of ± 15° in all directions.
Application 2: Use with IR receiver extension