![](/images/new-backgrounds/1117441/11744111x1.webp)
User Manual |
Double click My Computer/Control Panel/SCSI Adapters, then click the Drivers tab.
2.Click Add… then Have Disk....
3.Insert the Driver diskette into the floppy drive and type in A:\, then click OK.
4.Highlight Silicon Image
5.Remove the Driver diskette and restart Windows.
Verification of the Proper Installation for Windows NT 4.0
1.Double click My Computer/Control Panel/SCSI Adapters.
2.Highlight Silicon Image
2.4.Windows 2000 Driver Installation
For New Windows 2000 Systems
1.After the Serial ATA PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly.
2.At the Windows
3.Insert the Driver diskette. Press S, then press Enter.
4.Select Silicon Image
5.Press Enter to continue and follow
For Existing Windows 2000 (in old ATA channel) Systems
1.After the Serial ATA PCI Host Adapter and attached drives are configured, boot up Windows.
2.At the Found New Hardware Wizard, click Next.
3.Select Search for a suitable driver for my device (recommended) and click Next.
4.Insert the Driver diskette into the floppy drive, check Specify a location, uncheck the other boxes, click Next, type in A:\. Click OK and then Next to continue.
5.If the Digital Signature Not Found message appears, click Yes. (Note If prompted for Windows 2000
6.Click Finish, remove the Driver diskette and click Yes to restart Windows to complete driver installation.
2.5.Windows XP Driver Installation For New Windows XP Systems
1. After the Serial ATA PCI Host Adapter and attached drives are configured, follow Microsoft procedures to install Windows accordingly.
2. At the Windows
3. Insert the Driver diskette. Press S then press Enter.
4. Select Silicon Image
5. Press Enter to continue and follow
Note: When the Software Installation warning pops up, click Yes. And when the Hardware
5