Q: The mouse cursor can only move left & right during operation (it could be caused by low battery or the optical sensor’s data error).
A:Please take out one of batteries and put it back for a power reset and then redo the connect procedure.
Q: The mouse does not work after waking up from power off mode by pressing the connect button once.
A:This might be caused by imprecisely depressing the connect button to wake up the mouse. Users can gain back normal operation by pressing connect button on the mouse first, and then pressing the one on the receiver. As soon as the LED inside the receiver starts flashing, the mouse is ready to operate.
Optical Sensor Mouse functions best on surfaces with details for tracking. It may not function on reflective, reflective pattern or
2.Reducing Interference with Other Wireless Devices
Reducing Interference with Other Wireless Devices:
All 27MHz
Move the receiver and the mouse closer to each other so that the receiver is relatively shorter in distance to the mouse than to other 27MHz transmitters. You may need to
Note: Avoid using this device on a metal surface because a large surface of iron, aluminum, copper, or other metal may act like a shielding to the RF antenna of the mouse and the receiver.
3. Interference with other RF wireless mouse
If the interference comes from other same model of RF wireless mice, please “Setting up connection between mouse and receiver” of the installation guide to switch to a new RF channel. A new identification code is also generated upon the completion of channel switching.
6