Wireless N Adapter RNX-N150PC User Manual
Rescan: Click to rescan the wireless networks.
Information: Display the information about WPS IE on the selected
network. List information includes Authentication Type,
Encryption Type, Config Methods, Device Password ID, Selected
Registrar, State, Version, AP Setup Locked, UUID-E and RF
Bands.
PIN Code: 8-digit numbers. It is required to enter PIN Code into
Registrar using PIN method. Each Network card has only one PIN
Code of Enrollee.
Config Mode: Enrollee or an external Registrar.
Table of Credentials: Display all of credentials got from the
Registrar. List information includes SSID, MAC Address,
Authentication and Encryption Type. If STA Enrollee, credentials
are created as soon as each WPS success. If STA Registrar, RaUI
creates a new credential with WPA2-PSK/AES/64Hex-Key and
doesn't change until next switching to STA Registrar.
Detail: Information about Security and Key in the credential.
Connect: Command to connect to the selected network inside
credentials.
Rotate: Command connect to the next network inside credentials
Disconnect: Stop WPS action and disconnect this active link. And
then select the last profile at the Profile Page of RaUI if exist. If
there is an empty profile page, the driver will select any
non-secure AP
Delete: Delete an existing credential. And then select the next
credential if exist. If there is an empty credential, the driver will
select any non-security AP.
PIN: Start to add to Registrar using PIN configuration method
PBC: Start to add to AP using PBC configuration method.
WPS associate IE: Send the association request with WPS IE during
WPS setup. It is optional for STA.
WPS probe IE: Send the probe request with WPS IE during WPS
setup. It is optional for STA.
Progress Bar: Display rate of progress from Start to Connected status
Status Bar: Display currently WPS Status
Note: When you click PIN or PBC, please don't do any
rescan within two-minute connection. If you want to abort this setup
within the interval, restart PIN/PBC or press Disconnect to stop
WPS action.
- 30 -