WIRING INSTRUCTIONS - FOR U.K. ONLY. SAFETY NOTES - FOR REWIREABLE OR MOULDED PLUG.
The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.
If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug) and an appropriate one fitted. Warning : dispose of a plug that has been cut from the power supply cord, as such a plug is hazar- dous if inserted in a live 13 A socket outlet elsewhere in the house.
Always replace, the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a replace- ment is obtained - make certain that only the correct fuse cover is used and fitted.
For plugs with a detachable fuse cover the replacement must be the same as the colour insert in the base of the plug, or as directly by the embossed wording on the base of the plug.
If the detachable fuse cover is lost, a replacement may be purchased from Rowenta Service Centre (see enclosed Service Information leaflet). Information for supply may also be obtained from the plug manufacturer.
U.K. ONLY - FITTING A PLUG.
Important: the wires in this lead are coloured in accordance with the following codes Blue, Neutral, Brown, live.
Please read the instructions given below before connecting the cord to a plug. if in doubt, please consult a qualified electrician. As the colours of the wires in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
• the wire which is coloured BLUE must be connected to the terminal which is marked with the letter “N” or coloured BLACk;
• the wire which is coloured BROWN must be connected to the terminal which is marked with the letter “L” or coloured RED.
Neither core is to be connected to the earth terminal of a
This appliance requires a 13 A fuse ASTA approved to BS 1362.
3 - RECOMMENDATIONS
Your hair must be untangled, clean and DRY (in order not to damage your hair).
1.Put your curling tong on a flat surface, balanced on its safety stand.
2.Mod. A : Plug in the appliance. Select the right temperature to curl your hair with efficiency and optimum care :
-1: fine or delicate hair
-2 : normal hair, thick or difficult to curl hair
2.Mod. B : Plug in the appliance and switch it on. Select the right temperature to curl your hair with efficiency and optimum care :
-• : fine or delicate hair
-•• : normal hair
-••• : thick or difficult to curl hair
Wait for 10 minutes until the appliance reaches the right temperature.
3.Part a thin section of hair
4.Open the spoon by pressing the automatic curl release and slide the tip of the hair section between the spoon and the barrel.
5.Release the tongs to close. Ensure that the tip of the hair section comes out on the other side of the spoon. Hold the stay cool tip with your free hand.
6.Turn the appliance in order to wrap up the hair section around the accessory. Wrap up the curl as near to the scalp as possible without getting burnt.
7.Hold the hair section in this position for approximately 20 seconds for tight curls (less than 20 seconds if you wish to have softer curls).
