GB

2 • PREPARING YOUR STEAM GENERATOR

Fill the boiler :

1. Place your steam generator on a stable, horizontal heat-resistant surface.

2. Ensure that your appliance is disconnected and cold.

3. Unscrew the boiler screw cap.

4. Using a water jug, fill with one litre of water.

5. Fill the boiler, taking care that the water does not spill over (1). If this occurs, remove the excess water.

6. Replace the boiler screw cap, screwing on tightly.

(1)

The water to use in your steam generator :

Your steam generator has been designed to operate using untreated tap water. However, if your water is very hard, mix it 50 % untreated tap water 50 % distilled or demineralised water.

Types of water not to use :

Heat concentrates the elements contained in water during evaporation. The types of water

listed below may contain organic waste, mineral or chemical elements that can cause spitting, brown staining, or premature wear of the appliance : water from clothes dryers, scented or softened water, water from refigerators, batteries, air conditioners, rain water, boiled, filtered or bottled water. Also only use distilled or demineralised water as advised above.

3 • INSERTING THE REMOVABLE “BURST OF FRESHNESS” CARTRIDGE

2 removable “burst of freshness” cartridges are provided in the product packaging.

Inserting the cartridge:

1. Open the cartridge housing drawer by pulling it out horizontally (2) 2. Remove the cartridge closing stopper (3).

3. Insert the cartridge in its housing, pressing down firmly

(an audible “click” indicates that the cartridge has been inserted correctly) (4).

4.Close the drawer again by pushing it in horizontally (an audible “click” indicates that the drawer has been closed correctly) (5).

(2)

CLICK

CLICK

(3)

(4)

(5)

Page 4
Image 4
Rowenta DG7160 manual Preparing Your Steam Generator, Inserting the Removable Burst of Freshness Cartridge