quantity 
only when the iron is at temperature setting •••.
Auto Steam function* Set the steam button to 
(fig.13) and the steam quantity will adjust automatically to the soleplate temperature.
8 • Shot of steam
(from temperature setting •• upwards)
IMPORTANT Leave an interval of 4 seconds between each shot and wait until the flow of steam is finished before standing the iron on its heel.
Press the shot of steam button 
to generate a powerful jet of steam and remove stubborn creases (fig.14).
9 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning delicate fabrics.
Hold the iron to the vertical and press the shot of steam button ( 
fig.15) to remove creases from suits, jackets, skirts, hanging curtains etc.
IMPORTANT Never direct the steam at persons or animals!
10 • Spray
Press the spray button 
to dampen stubborn creases (fig.16).
11 • Anti-Drip system*
It prevents water escaping from the soleplate when the temperature is too low.
12 • Automatic electronic 3-position cut-out*
If, although switched on, the appliance is not moved, it will automatically switch off and the auto off light will blink after the following intervals:
-After 30 sec., if the iron is left standing on the soleplate or lying on its side .
-After 8 mins., if the iron is left standing on its heel.
To switch the iron back on, move the iron gently.
* depending on model | 7 |
