Rowenta PH570 manual Maintenance, Protection of the Environment, Event of a Problem

Use cable gripper

Blue or

N black

Fit correct fuse

L

Brown or red

5. MAINTENANCE

CAUTION!: always disconnect the dryer before cleaning.

A- Cleaning the dryer:

-Your dryer needs very little maintenance. You can wipe with a dry or damp cloth.

Removable grill for easy maintenance:

this appliance is equipped with a rear grill and an ultra-fine filter (Fig.31) so as to prevent hair from entering the appliance. It is recommended to clean the fil- ter regularly.

-Never use surgical spirit or similar to clean your dryer.

-Never immerse the dryer or attachments in water.

-Dry the parts you have cleaned very carefully.

B- Cleaning the attachments:

-We recommend regular cleaning of the straightener attachments with the small cleaning brush provided.

-First remove the straightener attachment, then remove any hair clogging the plates, using the part of the cleaning attachment with rigid teeth (Fig.32), then finish with the soft brush.

GB

31

32

6. PROTECTION OF THE ENVIRONMENT

At the end of the life of your product, it should go to a specially-adapted waste recycling centre.

7. IN THE EVENT OF A PROBLEM

LISSIMA blows cool air !:

1)You have inadvertently pressed the "cool shot" button

2)The thermostat has cut out because the "Ultra-liss system" or rear grill need cleaning with the cleaning attachment (cf. Paragraph 5).

If the problem persists after cleaning, contact the After-Sales Service.

3)You are allowing your hair to remain too long in contact with the "Ultra-liss system".

The straightening effect is not efficient enough !:

Your hair is too wet, dry it off a little.

WIRING INSTRUCTIONS - FOR U.K. ONLY.SAFETY NOTES FOR REWIREA- BLE OR MOULDED PLUG

The mains lead of this appliance may be already fitted with a BS 1363 13 A plug. Should the fuse need to be replaced, a 13 A ASTA approved BS 1362 fuse must be used.

If your socket outlet is not suitable for the plug, then the plug must be removed (cut off if it is a moulded on plug) and an appropriate one fitted. Warning : dispose of a plug that has been cut from the power supply cord, as such a plug is hazardous if inserted in a live 13 A socket outlet elsewhere in the house.

Always replace the fuse cover after fitting a fuse. The plug must NOT be used if the cover is omitted or lost until a replacement is obtained - make certain that only the correct fuse cover is used and fitted.

For plugs with a detachable fuse cover the replacement must be the same as the colour insert in the base of the plug, or as directly by the embossed wording on the base of the plug.

If the detachable fuse cover is lost, a replacement may be purchased from an approved Rowenta Service Centre (see enclosed Service Information leaflet). Information for supply may also be obtained from the plug manufacturer.

U.K ONLY - FITTING A PLUG

Important : the wires in this lead are coloured in accordance with the following codes Blue, Neutral, Brown, live. Please read the instructions given below before connecting the cord to a plug. If in doubt, please consult a qualified electrician.

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows

:

• the wire which is coloured BLUE must be connected to the terminal which is marked with the letter " N " or coloured BLACK.

•the wire which is coloured BROWN must be connected to the terminal which is mar- ked with the letter " L " or coloured RED.

Neither core is to be connected to the earth terminal of a three-pin plug. This appliance requires a 13 fuse ASTA approved to BS 1362.