Manuals / Rubbermaid / Lawn and Garden / Outdoor Storage

Rubbermaid P0-5L20-P0 Door Finishing Installation, click, CAUTION Do not overtighten screws

Models: P0-5L20-P0

1 18

Page 17

5.0 Finishing Installation

a.
Install Screws (AA) into 8 locations shown at bottom of wall panels to secure walls to floor.	AA (8)
	AA (8)

HELPFUL HINT: Pilot holes may be drilled for the screws.

CAUTION: Do not overtighten screws.

5.1 Door Finishing Installation

a. Install Lock Hasp (X) into opening on Right Door (K).

b. Install Door Handle (T) onto Left Door (L) using four

Screws (AA).

AA (4)

click

Page 17

Image 17

Rubbermaid P0-5L20-P0 Door Finishing Installation, click, HELPFUL HINT Pilot holes may be drilled for the screws

Contents

Installation Steps Department can accurately and quickly assist you if necessaryBEFORE YOU BEGIN - PREASSEMBLY 5L205L20 PREASSEMBLYMATERIALS OR CLEANING TOOLS CAUTION Always use eye protection/safety glasses during assembly1.0 Site Preparation CAUTIONS4 places on Front Floor A Floor Installation8 places on Repeat Floor B of Repeat Floor B3.0 Wall Panel C Installation 2.1 Floor InstallationCAUTION Do not overtighten screws Screw Holesclick ALIGN 3.1 Wall Panel D Installation ab. Snap Repeat Left Side C into the back position of Repeat Floor B ALIGNclick 3.2 Wall Panel E InstallationHELPFUL HINT Lubricate dovetails with liquid soap b. Connect Left Back D into dovetails of Repeat Left Side Cb. Snap Repeat Right Side E into the back position of Repeat Floor B 3.3 Wall Panel F Installation aclickALIGN click click Install Wall ConnectorsDclick HELPFUL HINT Lubricate dovetails with liquid soapAlign the lap joint between Repeat Left Side C and 3.4 Wall Panel G InstallationNote This pilot hole is to be drilled through both walls Screw Holesclick 3.5 Wall Panel H Installation aclick d. Snap Front Left Side G into Front Floor ASnap Front Right Side H into Front Floor A clickclick 4.0 Roof Panel M back position Installation Page 4.2 Roof Panel J front position & Door Installation click Install Roof Pins four places1. Insert pin in slot 3. Rotate head flush with roof5.1 Door Finishing Installation 5.0 Finishing Installationa. Install Lock Hasp X into opening on Right Door K b. Install Door Handle T onto Left Door L using four Screws AACustomer Service MAINTENANCE & SAFETY