Russound user manual R10DT SUBWOOFER

R10DT SUBWOOFER

1 2 3 4 5 6

7

8

9

1Volume Level Adjustment: Increase or decrease the output level relative to the incoming signal.

2Crossover: Provides active filtering of the incoming signal to allow only lower frequencies to be ampli- fied. Adjustment range from 60Hz to 160Hz.

3Power Auto, On and Off: Auto setting - amplifier turns on when audio is detected. On - amplifier is always on. Off - amplifier is off.

4Phase Selection: The speaker Phase can be inverted 180 degrees. Used with more than one subwoofer or for abnormal room acoustics.

5Low-Level Line Input: Left and Right channel RCA connections for low-level audio signal feed.

6LFE Input: RCA connection for pre-filtered, low level signals from a processor such as home the- ater receiver

7Speaker Level Input: (with passthrough) Spring- loaded terminals for up to 12 gauge speaker wire. Allows input connections to be sourced from an amplified speaker signal such as the Left and Right output from an amplifier/receiver. This amplified sig- nal is tapped off for feeding the subwoofer but the signal is unaltered and is passed directly on to adjoining output terminals.

8Speaker Level Output: Spring-loaded terminals accept speaker wire up to 12 gauge in size. Output terminals feed audio to the speakers which would otherwise be directly connected to the amplifier/receiver’s main Left and Right outputs (those connected to the speaker level inputs).

9Power: Molded power cord for 120V 60Hz 1.25A power supply.

4