ASSEMBLY INSTRUCTIONS
This unit is completely assembled. However, some adjustments may be required to provide safe and easy use for the operator.
It is suggested that you mount the charging unit per instructions and allow the unit to charge for at least 36 hours prior to first use.
MOUNTING THE CHARGING STATION
Since this unit may stay on the charging station continuously without overcharging, it is suggested that the charging station be in a place where the unit is intended to be stored. This should be a place that is cool, dry and well ventilated, where the unit can be
Your unit should be charged and stored in a location where the temperature is more than 50˚F (10˚C) but less than 100˚F (38˚C).
1.Locate a place for the charging station near a wall outlet and high enough to keep the unit off the floor.
2.Locate the wall stud and mount the charging station to the wall using the three (3) screws provided (Fig 1). Make sure that the screws enter the wall stud to provide a secure mount.
CAUTION: To prevent injury or damage to the unit, the charging station must be mounted securely to the wall.
3.Plug the charger into the wall outlet and wrap any excess wire onto the cord wrap on the charging station (Fig. 1).
Screw
Charging
Station
Wall
Outlet
Charger
Cord
Wrap
Wall Stud
Fig. 1
INSTALLING AND ADJUSTING THE D-HANDLE
1.Push the
2.Insert the shoulder bolt and washer into the squared hole in the handle. Screw the wing nut onto the bolt.
3.Rotate the
4.While holding the unit in the operating position (Fig. 3), position the
Wing
Nut
Bolt
Washer
Fig. 2
Fig. 3
Grip
Fig. 4
7
